CS115 – 4 pole AC and DC Contactor
Multi-pole unidirectional DC or AC contactor up to 800 V and 30 A of continuous current. Main contacts and optional auxiliary switch in different combinations NC/NO.
CS115
This multi-pole AC or DC contactor of up to 800 V can switch and carry currents up to 30 A. Different combinations are possible for the 4 main contact pairs: 4 NO, 3 NO/1 NC or 2 NO/2 NC. Optionally, 1 to 4 auxiliary contacts can be pushed on (NC/NO contacts) which report the switch state of the main contacts to different systems.
As a DC contactor, the CS assumes control tasks in battery networks. The AC version can also switch AC voltages. Typical applications are the switching on and off of devices or subsystems, the mutual locking of switch circuits or the activation of power contactors. In a voltage range of up to 800 V DC, it can also function as a pre-charging contactor or discharge contactor.
Features
During switch off, an electric arc is ignited between the opening contacts. The current flows on through the ionised air. Permanent magnets drive the ionised air out of the contact zone into the arcing chamber. Here, the electric arc is extended and cooled until it goes out.
In this contactor, the permanent-magnetic blowout works for all four contact pairs. Depending on the voltage range, the shutdown power is significantly higher than the thermal continuous load.
The main contacts of the CS115/10 are available in the following configurations:
- 4 NO contacts
- 3 NO contacts/ 1 NC contact
- 2 NO contacts / 2 NC contacts
Optionally, one to four auxiliary switches can be pushed on (NO/NC) which report the switch state of the main contacts to different systems. Using the auxiliary switches, locks or safety circuits can be made, for example.
- Industrial trucks
- Battery-powered transport units
- Automated Guided Vehicles (AGVs) for intralogistics
- Rail carriages (tested as per EN 60077-1, EN 60077-2 and EN 61373)
In a voltage range of up to 800 volt DC, the CS can also be used as a pre-charging contactor or discharge contactor.
Specifications
| Type of voltage | DC (unidirectional), AC (f ≤ 60Hz) |
| Main contacts, configuration | 4 x NO/NC |
| Nominal voltage Un | 750 V (max. 800 V @ PD3, 1,500 V @ PD2) |
| Rated operating voltage Ue | 800 V @ PD3 1,500 V @ PD2 |
| Rated insulation voltage Ui | 800 V @ PD3 1,500 V @ PD2 |
| Rated impulse withstand voltage Uimp | 6 kV @ PD3 8 kV @ PD2 |
| Conv. thermal current Ith | 20 A @ 2,5 mm² 30 A @ 4 mm² mit Gabelkabelschuh |
| Aux. contact | max. 4 x NO/NC, silver, DC 13: 110 V, 0,5 A |
| Coil voltage Us | 24, 36, 72, 96, 110 V DC |
| Coil tolerance | -30% … +25% |
| Vibration / Shock (IEC 61373) | Category 1, Class B |
| Mounting orientation | horizontal, vertical |
| Temperature range | -40 °C … +70 °C |
| Mechanical endurance | > 5 million operating cycles |
What do you want to do?
Do you have questions about this product?
Bookmark product
